HeatShields are interior reflectors which are intended as temporary relief against heat buildup in the cockpit or cabin interior. The do keep the interior about as cool as exterior covers, but they can take longer to install and do nothing to protect the plexiglas or to prevent damage caused by leaks. Also, in aircraft equipped with laminated windshields, they may cause damage to those windshields because of excessive heat buildup near the glass. Our HeatShield material is a special laminate of metallized polyester film, laminated to a thin sheet of closed-cell foam. It is thinner than bubble-pack type reflectors, and has extremely good reflective and insulating qualities. Where an exterior cover is not considered practical by the operator, a HeatShield is often the best solution for cabin protection. TRI-FOLD RING INTAKE/EXHAUST COVERS are designed to install easily yet be completely storable. A spring steel hoop is sewn into the hem of each cover, allowing them to be installed without climbing onto the wing or using a stepladder. To store the covers the spring steel hoop folds like a band-saw blade into three nesting rings. Each cover folds into a compact circular bundle which is stored in the included duffle bag, yet they unfold quickly for use. Installation details vary by model, and whether or not thrust reversers are installed. The Tri-Fold Ring cover is made of medium weight nylon which is available in a variety of colors to match the paint trim. Each cover set comes complete with installation and folding instructions. The aircraft's registration number can be silkscreened onto the cover for an extra charge. eNGINE COVERS ARE AVAILABLE IN A VARIETY OF COLORS: RED, ROYAL BLUE, NAVY BLUE, MAROON, GREEN, ORANGE, SILVER, SMOKE, & BLACK. Pitot tube covers, made of Naughahyde vinyl, are designed to cover the entire pitot assembly. Slipping on over the tube, the cover tightens around the base with a special Velcro strap detail. A warning streamer is attached to the cover. Non-burning Pitot Covers are designed to withstand more than 500 degrees F., preventing damage to the pitot tube if the pitot heat is turned on while it is covered. The pitot cover for the Fairchild A10 is specifically designed to fit the "straight out" pitot tube located on the right wing. It is mainly constructed of bright red NaughahydeŞ supported vinyl material, cut to enable a friction fit over the pitot tube. A "Remove Before Flight" streamer is attached to the cover. The main seam is sewn securely, and triple-sewn at wear points. A description and part number are imprinted onto the side of the cover. | 
